We are readers supported. When you buy via links on this site, we may earn an affiliate commission. Learn more

Common Water Softener Problems

Updated on

Although water softening devices demand very less maintenance, still there may be chances that your device not function as required. It may suffers some common problems. This article will help you to know the common solutions of water softener problems.

If you happen to have these common water softener problems – troubleshooting is much easier than what most people think. This may seem like a complex issue. But we promise to break this down in simple terms and give you some step-by-step solutions to keeping your water soft.

Your water softener works to remove high levels of magnesium and calcium in your water. Too much of it hardens the water. The water softener replaces these elements with sodium in a brine solution. This cleanses the water, removing dirt in the process. Therefore, it’s really important to keep your water softener in good condition.

Here are some common water softener problems with some key solutions.

1. Low levels of salt content:

Without enough salt in your brine tank (where the salt goes to clean magnesium, calcium and other harmful materials ), your water runs the risk of getting hard. The solution: Check your brine tank on a monthly basis. If there are low levels of salt content, simply fill up your tank to about 2/3 of the way. You can use solar, rock or evaporated salt.

2. A Dirty Resin Bed

Your resin bed sits next to the brine tank. This is a critical piece where the softening process takes place. If it’s dirty, there is likely a build-up that can hold up the process. The solution: Use citric or phosphoric acid cleaners to wipe away the build-up and keep the softening process working.

3. A Dirty Injector

Finally, it’s important to check your resin injector which is located in the interior section of your resin tank. A dirty injector is likely clogged from deposits from water softening. The solution: Make sure that your softener is placed in a manual regeneration prior to cleaning up your injector. Thoroughly clean the injector (right side of the head) and the injector screen.

The Bottom Line

As always, trust your gut. It’s always best practice to consult with a professional when making big repairs to your water softener system.

Have you ever experienced problems with your water softeners? If, so you can share with us by putting few lines in the comment box below. Your contribution will help others to troubleshoot common water softeners problems in a favorable way. You may consider reading our top 10 best water softeners reviews post.

How to Remove a Salt Clog From Water Softener - Video

Leave a Comment